Headlight Relay Pics

[digitech]

Here are a few pics showing how I did my headlights. I ran power from the batt. to a distribution block, then to a couple of bosch relays ($3 a piece), one for high, one for low and of course, used the exisiting wires for control. Big time difference, as you've all pointed out! I did the same for the wipers, you can see the other feed wire coming off the block. I also did the grounds in my car in a similar fashion, I'll post some more pics later.

[mdrburchette]

Very clean work! Did you say you put the wiper circuit on relays too? How did you do that? Did you document your work? Alvon and I had talked about trying to figure out a way of doing just that several years ago, but I don't think we could come up with a feasable way.

[digitech]

I did do the same for the wipers and documented the changes. I will dig up the changes and post them - in the meantime, here are two pics showing how I mounted the new relays to the exisitng relay panel (I have a '79 Spider). Of course, I have cleaned out the ones I didn't need any longer.

[racydave]

Looks so clean!!! Did you fuse it all at the battery? I put my relays under the L/ dash at the cowl, and used in-line fuses. The feed for the ignition was close to the relays.

[digitech]

They're fused at the distribution block, it cleans things up a bit and makes it easier to T/S if there's a problem.

[amsiegel]

Very nice very clean. I like the labeling.

[mbouse]

berry nice

[digitech]

PM sent to Denise regarding the wiper ckt. hook-up.