Fender Flares

[fiesta54]

Does anyone have experience with the fender flares from autoricambi or midwest bayless? Any pics of them installed? Riveted and epoxied. Thanks!

[fiesta54]

Hmmm I guess not

[toplessexpat]

Fitting them right now .... will post pics when done.

[fiesta54]

Can't Wait!

[toplessexpat]

Me neither .... it's awaiting paint right now.

[fiesta54]

I'm taking a lot of inspiration for my car from yours, so I'm looking forward to seeing it!

[toplessexpat]

Crazy guy!

While I'm at it with the flares, I'm also smoothing out some of the welds etc. Removing the lip across the back, filling in the lower rear panel lines, and the front end welds. I'm also fitting mustang turn signals roughly where the "square" holes were (before they got filled in too!)

PM me your email and I'll send you some inflight pics.

[fiesta54]

I'm not sure if I understand which welds you are talking about? On the body or on the flares? I am filling in quite a few holes as well. I already have the square holes filled and am thinking about filling in the round holes and using the integrated turn signal/ headlights. I just hope it doesn't look too bare then. And you've been pm'ed good sir

[toplessexpat]

I'll send you some pics

[architect]

Bring up an old thread from the past...

I’m on the edge about fender flares.. anyone got pics of a normal spider with 2” flares?? Black?