IDF MANIFOLD IN PRODUCTION-PICS

[So Cal Mark]

Here are pics of the IDF manifold that are now in production and available to order. The flanges are cnc machined and port matched. These manifolds are set up for the newer 70 series Weber or EMPI IDF carbs. They can also be ordered to fit the older series Webers.
In the near future we'll be offering the complete setup with carbs, linkage, manifold and air cleaners.

[JDOliver]

Oh man Mark, all I can think of is a potential place for injectors, and building a custom system.
Can you PM me on price as pictured, and just a flange if you will sell one.

[So Cal Mark]

ideally, injector bosses should be right at the port, angled into the air stream. We can do that. What throttle bodies are you considering?

[JDOliver]

I was thinking of fab for a supercharger or front facing single throttle for an intercooler. I've seen that done already in a custom set up.

What are the ports for anyway? I notice they were too far out for injection.

[So Cal Mark]

they're vacuum ports, but we're going to reduce the number of them.