Wood in center dash
-
fiatjack
- Posts: 18
- Joined: Tue Aug 08, 2023 8:08 pm
- Your car is a: 1979 Fiat Spider 2000
Wood in center dash
Are there any tips for re-installing the wood around the hazard switch in the middle of the dash? The PO of my 79 spider 2000 used red JB weld, now that its all cleaned off (huge PITA), they dont sit inside on their own. looking for any suggestions, glue, tape, etc? Thanks in advance
-
18Fiatsandcounting
- Posts: 3780
- Joined: Fri Mar 15, 2019 11:23 pm
- Your car is a: 1969 and 1971 124 spiders
- Location: San Francisco Bay Area
Re: Wood in center dash
It is a bit tricky, and the issue is often that the center bezel has warped a bit and so those "slats" (boards) don't stay in place. If the bezel is flat, when it's pressed against the metal frame of the dash behind it, those slats should stay in place.
If not, perhaps install the slats with a small dab of silicone sealant on each corner before installing the center bezel?
-Bryan
If not, perhaps install the slats with a small dab of silicone sealant on each corner before installing the center bezel?
-Bryan