'72 hazard switch wireing order help

[ericsky]

While going after my heater blower I disconnected the hazard switch without marking the location order of the spade connectors on my '72 with the rocker style switch. I searched the forum and came across a post from offshore in 2011 when he had a similar issue sorting out his proper order using a diagram but I can't find the correct diagram. Any help here is greatly appreciated, thanks! Eric

[vandor]

There are letters by the terminals on the switch. According to the wiring diagram, the wires should go like this:

H - red
V - white
I - yellow/black
? - gray

[ericsky]

Thanks Vandor! I was hoping to get a reply just like yours with the letters. But my switch has 6 terminals and I thought atleast 5 of the 6 were used and I do have an extra black/white wire? I'll try this tomorrow and should have enough with this to make it work. Thanks again for the quick response and hopefully I learned better this time to mark wires next time.

[vandor]

Two of the 6 terminals are for the bulb inside (the '72s originally did not have the bulb). They should be the 2 connectors on one side, the side where the rocker has the light. So you do not need to connect anything there.

[mdrburchette]

Csaba helped rewire mine during my visit to Dallas. Good luck with it.