what to use to cutout for speakers?

[akavinn1]

i am putting in speakers near the map pockets but need to cut wholes in the metal anyone have any ideas hw to sut them ?

[rlux4]

Drill some holes on your pattern and then cut between the holes with an air reciprocating saw, with a short blade. I like a 4-1/2 grinder with a metal cutting blade, but it wouldn't be practical in such close quarters. A sawzall or jigsaw would work for the cutting, but an air tool is smaller and more maneuverable.
Ron

[akavinn1]

That's a lot of holes lol

[rlux4]

Nah, you'd only need enough to cut between. I'd use three or four. Other than a starter hole to get a blade into the purpose fo the drilled holes is to make shorter runs between cuts. You could get by with one starter hole if you didn't mind cutting the whole 360° with a blade.
Ron