It seems I have to make a bracket extending the stock trans mount, and that bracket will at first have to have built in tension to guide the header tubes away from the block where they seem to point. I hope they heat and take shape, but I think its more likely they will heat and crack, but at this point I have few options other than heating and bending them which will obviously toast the black paint they come with.
Anyone else experience this?
Josh
p.s. Mark I know I should have bought yours, but yours are just to damn nice which means they are to damn expensive
and cut and re-weld the entire thing so it does hit everything...
. Not to mention that the downpipes hit the crossmember as your putting them on the header. The last thing is that nice looking black paint. Say goodbye to it in about 4 minutes. They should really be using header paint, not paint for plastic lawn furniture. Mine still smoke and its been a few days. I was hoping for a two and a half inch outlet instead of the stock size. That was a bummer too. what is it, an inch and a half? maybe five eights.
