Anyone have a vector file of dash parts?

[jimmycakes401]

I've been searching the forums and see a lot of folks talking about CNCing new dash parts. I have access to a CNC and would like to do the same. I don't have a file. I can create one, I was just hoping to find someone who already made one. Thanks if anyone has one!

[jimmycakes401]

If anyone can scan in their 1981 dashboard (to scale) I will make a vector file of it and make it available for download. I just want to customize my dash and my tabloid scanner just broke down.

[SoFlaFiat]

I recently cut a one piece dash for my 1977 and could send the dxf. I use Alphacam and will share that file happily if it does you any good. I did have to trim the outside edge but have reworked the program to reduce that issue. Probably makes sense to leave a little to trim anyway.

[jimmycakes401]

I think I would like to have that on file! Thanks!

[DocGraphics]

Yes me too....PM sent

[swede]

Yes me too, I might even convert it to siolidworks 3D cad.
... pm sent

[basarabam]

[sherwood]

I would like a copy as well. dxf is fine or solidworks ok too. Thanks in advance for your efforts!